Nipple clamp

From wipipedia.org
(Redirected from Tit clamp)
Jump to: navigation, search


clover clamps
Model with clamps and ring gag from Westward Bound
more painful clamps
medical clamps

A nipple clamp is a clamp used to stimulate the nipples by applying varying degrees of pressure. They are often used in BDSM activities, on both men and women.

Weights may be hung from the clamps to increase the force on the nipples. This also discourages the clamped person from moving suddenly (for example, jumping when spanked or caned), since this would make the weights swing and increase the pain. The weights may be on springs; this is supposed to increase the effect of the weights moving because they will bob up and down, but this does not work well in practice.

In their simplest form, nipple clamps are a variation on an alligator clamp, often with an adjustable spring or locking device. The tips should be covered with cork or soft PVC or rubber, both for traction and to give some cushioning to protect the skin and tissues.

The main types of nipple clamp are the clover clamp and the tweezer clamp. The common household clothespin is also popular. However, any device that can be used to apply direct pressure can be used. Another type of clamp is based on a forceps design. They look like a pair of scissors, and have a locking device between the arms to hold them in place.


Tweezer clamps

Tweezer clamps consist of two short lengths of metal, no more than 5–10 cm (2–4 in) in length. The ends are curved slightly to improve their ability to grip the nipple. They usually have a small 1 cm rubber sheath over this end to protect the nipple from damage. A small ring wraps around the two pieces of metal and is used to adjust the tension. The user places the two sides of the metal head either side of the nipple, then (by sliding the ring along the clamp shaft towards the nipple) causes the two halves to close tighter together. Tension can thus be adjusted depending on the location of the ring — the closer the ring is along the shaft toward the nipple, the tighter the clamp.


Clover clamp

The clover clamp, also referred to as a "butterfly clamp", is of Japanese design, and has the ability to provide increasing tension if pulled on. The clamp itself is flat, but about 10 cm by 5 cm in size. Using spring tension, the clamp is applied to the nipple and the tension of its spring holds the clamp in place. This clamp often provides a very high pain level, and is not recommended for beginners. To increase tension on the nipples, small weights such as fishing line sinkers can be attached to the ends of the clamp. As increased pulling tension is applied to the clamp, it will cause the jaws of the clamp to close tighter depending on the amount of pull pressure. Another method is to use the clamps to keep a person in one place. If cord is tied from the clamp to a fixed place, the wearer of the clamps cannot move away because the clamps will tighten as they try to move. The clamps would eventually be pulled off the nipples, but not before great pain is felt.


See also


Smallwikipedialogo.png This page uses content from Wikipedia; the original article can be viewed here.
Personal tools
Namespaces

Variants
Actions
Navigation
Tools